News - How to replace pendant light

How to replace the pendant lights are skilled, summarize my experience in replacing the pendant lights.

Now the lighting decoration is more and more sophisticated, the chandelier is also an indispensable part, today we will introduce how to replace the chandelier, and what are the considerations when replacing.

Pendant lamp manufacturer

1.Removal of old chandeliers

1. the removal of the chandelier, the first step is to cut off the power supply, which is the most important one.

Step 1: Cut off the power supply.

Step 2: Use a small screwdriver or small thin blade from the seam side of the aluminum buckle plate warp up a corner, take down the lampshade.

Step 3: Pull off a small piece of the aluminum panel in the same way, and remove the bulb.

2. there is another kind of chandelier is used in the round ceiling chandelier, this kind of chandelier removal steps have such a few steps:

Step 1: Turn off the power, only the power is turned off, to ensure that your next work is safe;

Step 2: Use a screwdriver to remove the three screws around the iron ring of the lampshade, and then rotate the lampshade until it is unscrewed;

Step 3: Remove the bulb.

2. the chandelier removal precautions

1. chandelier demolition time to consider the security of this roof. If it is placed on the ceiling, it is likely that the building structure is already starting to age, plus the original ceiling decoration due to the renovation requirements of the large many holes, thus reducing the local load-bearing capacity.

2. in the ceiling if there are very much equipment, in the removal of the chandelier, it is necessary to avoid these arrangements, to avoid affecting the normal use of other electrical equipment. In principle, other wires need to be avoided when removing, and the original internal wires and water pipes are issues that need to be avoided.

3. replace the new chandelier

1. Install the new chandelier bracket at the original location where the old chandelier was removed, use the screws to connect it to the junction box, and then screw the fixture into the ceiling, it is important to ensure that the new chandelier bracket installed is kept straight.

2. Connect the wires on the fixture. The first connection is the ground wire of the chandelier, then the zero wire, and finally the fire wire. Connect the wires and then twist the wires together and secure them with wire nuts at both ends.

3. Check the height of the new chandelier to reach the ideal lighting decoration, if it is too low or too high, loosen the set screws in the cover and adjust the power cord to the desired length.

4. After connecting all wires firmly, use the screws to attach the cover to the junction box. Tuck the wires into the box and close the junction box.

5. Install the bulb of the new chandelier, turn the power back on and make sure the light is working properly. Thus the chandelier replacement is complete.